The shower is an essential sanitary ware for the shower. The pace of life for modern people is accelerating. You can waste too much time on the bath and the appearance of showers, so that you can enjoy your leisure time efficiently and comfortably. But remember, the shower installation is also very particular, the wrong installation process, the shower column and the neck, is not a very wonderful thing!
Shower installation height
The installation height of the shower is clearly defined in the industry. The shower is mainly divided into a shower and a shower. With relevant regulations, the height of the installation of the shower can be set at a height of 2.1 meters from the ground at the center of the wall and the depth of the shower switch is 1.1 meters from the ground; and the shower is generally defined by the shower surface. The height of the shower installation is preferably 2 meters from the ground. The height of such a shower installation is generally specified and can be determined according to your wishes if needed.
Shower installation process
Although the shower is small, but there are many parts, you must be optimistic about the instructions before installation, and then determine the installation location. When installing the shower, mark the installation position of the shower on the wall according to the height of the group, and then punch the wall. After punching, the circular bottom cover in the accessory is screwed to the wall, and then the shower It is fixed on the wall surface; after the shower is fixed, it is screwed tightly, and finally the shower hose is installed, and the hand shower can be installed.
Shower installation details
1. It is necessary to punch holes when installing the shower. When drilling holes, it should be noted that the water pipes in the wall cannot be penetrated;
2. When installing the circular bottom cover on the shower, be sure to tighten the screws, otherwise the shower will fall off;
3. When the hand shower is installed, it cannot be robbed or distorted;
4. Before installing the shower, be sure to determine the height of the installation and mark it.
Exterior Porcelain Tile size: 1800x900mm, 1500x750mm, 1200x600mm, 800x800mm, 600x900mm...
Thickness: 5.5mm-12mm
Characteristic of Outdoor porcelain tiles
1. Light and thin, saving raw material resources, and reducing overall consumption, reducing the load of the building itself, the effect of high-rise building engineering is more obvious.
2. Water absorption rate <0.1%, no cracking phenomenon, Exterior Wall Porcelain Tile have superior physical properties, sturdy and durable, good weather resistance and long service life.
3. Exterior ceramic tile is easy to clean, fireproof, water resistant, wear resistant, corrosion resistant and low maintenance cost.
4. The color is rich and stable, and the Exterior Wall Ceramic Tiles surface has various effects. The exterior wall tile surface has a variety of textures, whether it is shiny or flat or rough, and has a rich and varied design and a strong decorative effect.
5. Easy to cut. For some large walls, large
Exterior Porcelain Tile Cladding has a better
visual effect. Designers can also cut large-sized tiles according to their
design needs, and cut and process them to get the most suitable tiles.
Application construction system
1. Tile adhesive construction: use a serrated boring tool to evenly scrape the cement-based adhesive on the construction base layer, then press the porcelain plate into the adhesive, tapping with a wooden pole, a rubber hammer, etc., so that the tile and the adhesive stick more firmly.
2. Building porcelain panel dry-hanging system.
3. Construction porcelain decoration insulation board construction system.
Exterior Porcelain Tile
Exterior Porcelain Tile,Exterior Ceramic Tiles,Exterior Wall Porcelain Tile,Exterior Wall Ceramic Tiles,Outdoor Porcelain Tiles,Exterior Porcelain Tile Cladding
UMS New Materials Industry Co.,LTD , https://www.ums-factory.com