Explosion-proof positive pressure cabinet installation

1. The installation position of the cabinet: there is a roof in the room or outdoors, there is no obvious vibration and flat place.

2. The installation method of this product is floor-standing and wall-mounted. This cabinet is equipped with mounting holes specially designed for fixing. The specific parameters can be found in technical accessories or product types.

3. The wiring mode is cable wiring. The user cable structure can refer to the relevant national standards and industry standards, and combine the structural requirements of the cabinet for design and construction.

4. Pay attention when handling, this product is strictly prohibited to tilt, the slope is less than 100.

5. When this product is transported and installed, it is forbidden to carry it by means of hammers or hammers. Otherwise, the sealing performance of the product may be affected and the product may not operate normally.

6. This product is equipped with air intake and exhaust ports for users to take over. The user shall arrange the air intake pipe according to the “airline piping layout plan”. After the exhaust port passes through the fire damper, it shall be discharged on the site or lead to the safe area. The user shall provide the air supply source (protection gas) at the site, and the air source pressure shall be generally controlled. At 0.2-0.6 MPa, the intake air source is purified air (eg instrument air) or nitrogen, (Note: Use nitrogen as a protective gas with caution in a closed operating room. If nitrogen must be used as a protective gas, note that On-site ventilation to ensure personal safety).

7. Due to the built-in industrial electrical appliances, touch screens and other precision appliances, a dry filter must be installed at the air source inlet to ensure that the air source is dry and clean air, otherwise it will affect the service life of the appliance.