After shopping around, carefully selecting the floor, have all the steps been completed? Of course not, the floor acceptance is also an important part. After the floor is paved, it is best to carefully investigate if you are not satisfied. It can also be adjusted in time. How to check and accept the paved wooden floor?
First, see if the color difference is large
If the color difference is too large, it directly affects the appearance, and can be exchanged. If the color is too consistent, there is almost no color difference, then it depends on whether the pattern on the floor surface is the same. If the patterns are similar, it may be a craft wood floor, not a so-called floor material of precious wood. Some flooring materials suppliers now use ordinary wood flooring, but they are covered with a layer of precious wood veneer on the surface to shoddy the surface. The reverse side is covered with aluminum po, which is said to be used for moisture protection. In fact, it is afraid to be seen. The opposite pattern is inconsistent with the front. Wood is natural and retains its natural characteristics. The texture and texture of different parts of each tree are different. Therefore, the solid wood floor has color difference, but the installer will put the floor color separation during the installation process. In different positions, play a natural transition.
Second, see if there is a noise
During the acceptance, walk back and forth on the floor, the footsteps need to be aggravated, especially the wall parts and the door hole parts should pay more attention to the acceptance, and find the parts with sound, you must repeat the movement, determine the specific position of the sound, and mark well. In this case, you can ask to remove the resurfacing. The parts with sound are caused by unqualified operation and unqualified materials during the construction process. The operation is not standardized, which is mainly reflected in the fact that the ground keel is not firmly fixed; the material failure is mainly reflected in the fact that the ground keel has not been dried. Some renovation construction units use unground keel construction, and there are signs of drying on the surface, but they are not dry.
Third, see if it is deformed or warped
The method of acceptance is to use a 2 meter long ruler, leaning on the floor, the flatness should not be more than 3 mm, and take a few more measurements. If the pass rate is above 80%, it is qualified, otherwise it is unqualified.
Fourth, see if there are blinks, gaps, scratches
It is common because the ground keel is untreated, there are mites inside, and when it is found that there is a blink, the floor has been almost smashed. Gap and scratches are known at a glance. The gap of the floor should not be greater than o.5 mm. The scratches are mainly caused by rough decoration. If it cannot be repaired by waxing, it must be exchanged.
Potassium Sulfate can be used as an ingredient in a lot of medicine such as glucosamine chondroitin. It can also be used as a flash reducer in artillery propellant charges.
Potassium Sulfate
Potassium Sulfate,Sulphate of Potash,Potash of Sulfur,Food Grade Potassium Sulfate
Jiangsu Kolod Food Ingredients Co., Ltd. , https://www.kolodchem.com